Percentage Weighing Function; Automatic Mode With Reference Weight - Accuris W3101A-120 Operation Manuals

10.5 Percentage weighing function

This function allows you to read the weight as a percentage of a reference weight. The
reference weight is assumed as the 100% value (factory setting).
There are two modes for the acquisition of the reference weight – an automatic one (with
reference weight), and a manual one (with the manual entry of the value of the reference weight).

10.5.1 Automatic mode with reference weight

1. Select the percentage weighing function as described in paragraph 10.
The following screen will be shown on the display:
Percent weight
2. Confirm automatic mode by pressing the PRINT button.
3. The tare will be carried out and you will be asked to load the reference weight on the plate.
4. Load the reference weight on the plate and then press the PRINT button; the word "Wait"
will be shown. Once the weight is acquired, a screen with an indication of the weight loaded,
reference weight, and percentage weight will be shown.
5. Now remove the reference weight, load the sample and read the percentage weight.
6. Press the ON/OFF button to exit from the percentage weighing function.
NOTE: If the reference weight entered is less than 10 displayed digits, the word ERROR 07 will be shown.
01-06-10
Automatic
Select the mode
Percent weight
01-06-10
Load the reference weight
And press 'Print'
Percent. weight 01-06-10
P: 50.000 g
P%.
E premere ' Print'

13:15:24
13:15:24
13:15:24
RIF: 100.0000 g
50.00 %
47