Siemens SINAMICS G120C Getting Started page 26

Installing
3.2 Connecting
Default setting 7: Switch over between fieldbus and jogging using DI 3
Selected with
STARTER: Fieldbus with data set switchover
•
BOP-2: FB cdS
•
Factory setting for inverters with PROFIBUS interface
PROFIdrive telegram 1
Default setting 9: Motorized
potentiometer (MOP)
Selected with
STARTER: standard I/O with MOP
•
BOP-2: Std MoP
•
Fieldbus interface is not active.
Default setting 14: Switch over between fieldbus and motorized potentiometer
(MOP) using DI 3
Selected with
STARTER: Process industry with fieldbus
•
BOP-2: Proc Fb
•
PROFIdrive telegram 20
26
Fieldbus interface is not active.
Default setting 12: Two-wire control
with method 1
Selected with
STARTER: Standard I/O with
•
analog setpoint
BOP-2: Std ASP
•
Factory setting for inverters with USS
interface
Fieldbus interface is not active.
Fieldbus interface is not active.
Default setting 8: Motorized potentio-
meter (MOP) with safety function
Selected with
STARTER: MOP with Basic Safety
•
BOP-2: MoP SAFE
•
Fieldbus interface is not active.
Default setting 13: Setpoint via analog
input with safety function
Selected with
STARTER: Standard I/O with
•
analog setpoint and safety
BOP-2: ASPS
•
Fieldbus interface is not active.
SINAMICS G120C converter
Getting Started, 04/2014, FW V4.7, A5E34264105B AA