GE DMS Go+ Operating Manual page 57

Power supply
Connecting the instrument
Connect the DMS Go+ to the mains socket-outlet by
means of the corresponding charger/power adapter.
The socket-contact for connecting the charger/power
adapter is located on the side of the DMS Go+.
– Align the Lemo plug of the charger/power adapter
with the red mark on the socket (1).
– Push the plug into the socket until it locks into place
with a clearly audible click.
– When removing the Lemo plug, pull the metal sleeve
on the plug back first in order to open the lock.
A T T E N T I O N
In order to power the instrument off correctly,
press the power On/Off key (2) on the side of
the instrument. If the power supply is inter-
rupted (removing the battery, disconnecting
the power plug), the operation does not end
correctly.
DMS Go+ Edition 4 (05/2014)
3 Initial start-up
1
2
3-3