Table of Contents
Advertisement
1 Introduction
1.1 Safety information
The DMS Go+ has been designed and tested according
to DIN EN 61010-1: 2011-07, Safety requirements for
electrical equipment for measurement, control and lab-
oratory use, and was technically in perfectly safe and
faultless condition when leaving the manufacturing
works.
In order to maintain this condition and to ensure a safe
operation, you should always read the following safety
information carefully before putting the instrument into
operation.
A T T E N T I O N
The DMS Go+ is an instrument for materi-
als testing. Any use for medical or any
other applications is not permitted!
The instrument may only be used in industri-
al environments.
The DMS Go+ is waterproof according to IP67. It can be
operated either with the corresponding lithium-ion bat-
teries or with the charger/power adapter. The charger/
power adapter meets the requirements of electrical
safety class II.
1-2
Battery operation
For the battery operation of the DMS Go+, we recom-
mend the corresponding lithium-ion battery. You should
only use this battery for the battery operation.
You can charge the lithium-ion battery either within the
instrument itself or in an external charger. If a lithium-ion
battery is inserted, charging starts automatically as
soon as you connect the charger/power adapter to the
DMS Go+ and to the mains power supply.
For power supply, please also see Chapter 3.2 Power
supply, page 3-2. For the use of batteries, please also
see Chapter 8.2 Battery care, page 8-2.
Software
According to the current state of the art, software is nev-
er completely free from errors. Before using any soft-
ware-controlled test equipment, it is therefore neces-
sary to make sure that the required functions operate
perfectly in the intended combination.
If you have any questions about the use of your test
equipment, please contact your nearest representative
of GE.
Edition 4 (05/2014)
Safety information
DMS Go+
Advertisement
Table of Contents
