Table of Contents
Advertisement
8 Maintenance and care
– Press the function key 2 (1), the function key 4 (2),
and the Power key (3) at the same time, and hold all
three keys pressed until the display screen is turned
on and the message FLASH UPGRADE MODE ap-
pears.
The installation process will then start. The following
messages are displayed one by one:
LOADING FILE
VERIFYING FILE
PROGRAMMING FLASH
At the end of the installation, the instrument is powered
off automatically. After this, you can power the DMS
Go+ on again and use the new software version.
N o t e
For resetting the instrument to factory default
settings, see Section Factory default set-
ting (Reset), page 3-12.
8-6
1
2
Edition 4 (05/2014)
Software updates
3
DMS Go+
Advertisement
Table of Contents
