Table of Contents
Advertisement
10 Appendix
Function
VEL REF. BLOCK
CALIBRATION
Master Cmt
LOAD P-SET
LAST READING
MAX
MAX ALARM
MAX GAIN MODE
MAX GAIN
MENU MODE
TG MODE
MIN
MIN ALARM
MODE
NOMINAL
ZERO
ZERO BLOCK
10-22
Function group
CONFIG
PROBE&CAL
DR
PARAM
CONFIG
ALARM
ALARM
MEASURE
MEASURE
CONFIG
PROBE&CAL
ALARM
ALARM
MEASURE
MEASURE
PROBE&CAL
CONFIG
Description
Calibration block data for the operating modes TopCOAT and
AUTO-V.
Start of calibration to the sound velocity.
Editing the master comment list.
Loading of instrument settings from a file on the memory card.
Display of the thickness value that was measured last.
Alarm function for exceeding a maximum value.
Wall thickness value which triggers an alarm if exceeded.
Choice of amplification method.
Setting of gain values for the selected amplification method.
Disabling the access to the instrument setup function.
Choice of the suitable measurement mode for the probe type.
Alarm function for falling below a minimum value.
Wall thickness value which triggers an alarm if fallen below.
Choice of the operating mode.
Setting of nominal value for the differential value display.
Choice of the probe zero offset method.
Data of the reference block for the probe zero offset.
Edition 4 (05/2014)
Function directory
see page
5-48
5-27
6-8
5-19
5-4
5-39
5-39
5-34
5-34
5-8
5-22
5-39
5-39
5-17
5-46
5-25
5-48
DMS Go+
Advertisement
Table of Contents
