Basic Operating Procedures; Connecting The Printer - Avery Dennison AP 4.4 User Manual

05/04 Rev. 1.2-03

Basic Operating Procedures

1. Ensure that the printer power switch is set to "0" (Off).
2. Connect the printer to the power supply using the cable provided.
3. Using the data cable supplied, connect the Centronics interface on the prin-
4. Turn on the printer using the power switch (switch to position "1").
5. By pressing the online button you can switch to the online mode:
USER MANUAL
AP4.4 – AP5.4

Connecting the Printer

WARNING!
Printer is driven by mains voltage! Touching of live parts can cause life-
threatening body currents and burns!
Make sure, that the machine is switched off, before connecting the power
cable.
Only connect the printer to a power socket that provides the correct voltage,
which can be found on the rating plate.
Only connect the printer to a grounded power socket fitted to authorized
standards.
When laying the power supply cable, ensure that:
– no one can trip over it.
– no one can step on it.
– the power supply cable can be pulled out of the power outlet, if
necessary.
ter to the host computer.
Display
System start...
System start...
Start user prog
Avery AP 5.4
V 1.02
Memory: 8MB
Flashcard: 32MB
OFFLINE 0 JOBS
Tab. 4: Messages on the display once the printer has been turned on.
ONLINE 0 JOBS
When the parameter SYSTEM PARAMETER > Turn-on mode is set to
Online, the printer switches directly to online mode when it is turned on!
Meaning
The boot loader has started.
Valid firmware program recognized, program will
be started.
Printer type (here: AP 5.4)
Version number of the printer firmware.
Internal RAM (here: 8 MB)
Optional RAM on the CompactFlash card (here: 32
MB) – only displayed when a CompactFlash card
is in use.
Offline mode
14
Setup & Operation