Avery Dennison AP 4.4 User Manual page 4

05/04 Rev. 1.2-03
•
AP 5.4 with Cut-
ter
You can find instructions on how to mount the cutter in the cutter manual under
"Connection, Setup, Service".
•
AP 5.4 with In-
•
ternal Rewinder
•
•
AP 5.4 Dispen-
•
ser
•
•
USER MANUAL
AP4.4 – AP5.4
Tool which is used to replace the print roller and to mount a dispensing edge.
Cutter (Fig. 4)
Only if you ordered the "AP 5.4 peripheral with cutter".
Fig. 4: If ordered, you will find the cutter in a special carrier in the top of the printer pak-
kaging.
The cutter hook, a part which is required to mount the cutter, can be found
fixed to the printer bottom.
Printer with mounted deflector
Housing front part, bottom side with screw (fig. 5 right side)
Cutter flange cover with screws (fig. 5 left side)
It is recommended to mount the housing parts, if the printer is used as a
standard device without rewinding function.
Fig. 5: These housing parts are shipped loose with the „AP 5.4 Internal Rewinder".
Printer with mounted dispensing edge
Housing front part, bottom side with screw (see fig. 6)
Cutter flange cover with screws (see fig. 6)
Deflector (see fig. 6)
Enables the AP 5.4 Dispenser to be operated with internal (label material)
rewinder.
It is recommended to mount the housing parts, if the printer is used as a
standard device without dispensing or rewinding function.
4
Setup & Operation