Engine Start - Rotax 912 Series Operator's Manual

Oil level (oil
dipstick)

3.4) Engine start

Engine start
Page 3-6
November 01/2016
NOTE
The oil level should be in the upper half (between the "50%"
and the "max" mark) and should never falls below the "min."
mark. Prior to long flights oil should be added so that the oil lev-
el reaches the "max" mark.
Avoid oil levels exceeding the "max" mark, since excess oil
could be poured out through the venting system.
Difference between max.- and min.- mark = 0.45 litre (0.95 liq
pt).
ENVIRONMENT NOTE
Protect the environmental.
Observe to bury no oil! Dispose of oil in an environmentally friendly
Non-compliance can result in serious injuries or death!
Do not start the engine if any person is near the running engine.
Step Designation
1 Fuel valve
2 Starting carb
IF
engine in operating
temperature
3 Throttle lever
4 Master switch
5 Ignition
Do not actuate starter button (switch) as long as the engine is
running. Wait until complete stop of engine!
Step Designation
6 Starter button
BRP-Rotax
manner.
m WARNING
Procedure
open
activated
Then
start the engine without
choke.
set on idle position
ON
both circuits switched on
ATTENTION
Procedure
actuate
Effectivity: 912 Serie
Edition 4 / Rev. 0