To Observe - Rotax 912 Series Operator's Manual

To observe

Effectivity: 912 Serie
Edition 4 / Rev. 0
Activate starter for maximum of 10 seconds only (without inter-
ruption), followed by a cooling period of 2 minutes.
Step Designation
7 As soon as engine
runs
8 Oil pressure
At an engine start with low oil temperature, continue to observe
the oil pressure as it could drop again due to the increased flow
resistance in the suction line. The number of revolutions may
be only so far increased that the oil pressure remains steady.
Step Designation
9 Starting carb (choke)
Reduction gear with shock absorber
Since the engine comprises a reduction gear with shock ab-
sorber, take special care of the following:
Step Procedure
1 To prevent impact load, start with throttle lever in idle po-
sition or at the most up to 10% open.
2 For the same reason, wait for around 3 sec. after throt-
tling back to partial load to reach constant speed before
re-acceleration..
3 For checking the two ignition circuits, only one circuit
may be switched off and on at a time.
BRP-Rotax
ATTENTION
Procedure
adjust throttle to achieve
smooth running at approx.
2500 rpm.
check if oil pressure has ris-
en within 10 seconds and
monitor oil pressure. In-
crease of engine speed is
only permitted at steady oil
pressure readings above 2
bar (30 psi).
ATTENTION
Procedure
de-activate
ATTENTION
November 01/2016
Page 3-7