Safety; Measurement; Symbols Used - Rotax 912 Series Operator's Manual

1.3) Safety

Revisions

Measurement

Symbols used

Effectivity: 912 Serie
Edition 4 / Rev. 0
Although reading such information does not eliminate any haz-
ards, it promotes the understanding and application the infor-
mation will promote correct use of the engine. Always apply
common workshop safety rules.
The information and descriptions of components and systems
contained in this Manual are correct at the time of publication.
BRP-Rotax maintains a policy of continuous improvement of its
products without imposing upon itself any obligation to retrofit
products previously manufactured.
BRP-Rotax reserves the right to remove, replace or discontinue
any design, specification, feature or other at any time, and with-
out incurring obligation.
Specifications are given in the SI metric system with the imperi-
al- and US customary measurement system equivalents in
parenthesis.
This Manual uses the following symbols to emphasize particular
information. This information is important and must be
observed.
Identifies an instruction which, if not followed, may cause seri-
ous injury or even fatal injury.
Identifies an instruction which, if not followed, may cause mi-
Identifies an instruction which, if not followed, may severely
damage the engine or could lead to suspension of warranty.
NOTE
Indicates supplementary information which may be needed to
fully complete or understand an instruction.
BRP-Rotax
m WARNING
m CAUTION
nor or moderate injury.
ATTENTION
Page 1-7
November 01/2016