Fujitsu ETERNUS DX60 Operation Manual page 67

Subject of Configuration
NAS Interface (network)
NAS Interface (Port)
RIP Setting Enable/Disable
Configure whether to enable/disable RIP configuration.
When the RIP setting is enabled, its own routing table will be automatically generated based on the routing table broadcast from
the router connected to the port, and the access route set in the NAS interface can be automatically selected.
When the RIP setting is disabled, there will be dynamic generation of the routing table.
Point
-
When the RIP configuration is enabled, in order to dynamically create the routing table of the NAS interface, enable the RIP
configuration of the router that is connected.
-
When the RIP setting is disabled, the NAS interface cannot select its own access route. Set the routing table manually using
the ETERNUS Disk storage system command.
Port for Access
Configure the Allocation port and the Redundant port of the NAS interface. The shared folder will be accessed via the port configured
as the Allocation port.
When the Allocation port is down, the shared folder can be accessed via the port configured as the Redundant port. It is also
possible to use a single port operation format where a Redundant port is not configured.
Point
-
By setting the VLAN ID, 1 port can be allocated to multiple NAS interfaces.
-
The following ports cannot be selected for the Allocation port:
-
Member ports of bonding port
-
The following port cannot be selected for Redundant port:
-
Port of same CM as assignment Allocation port
-
Redundant port of other port
-
Member port of bonding port
-
When a Redundant port is not configured, it will not be possible to access the shared folder when the Allocation port goes
down. For this reason, it is recommended that a Redundant port be configured.
Connection Access Method
Configure the Allocation port and Redundant port for the shared folder access connection method.
The method for configuration of the connection type is as follows:
Connection Settings
Single connection
Active-Standby
connection
Specify only an Allocation port, and create a NAS interface.
Specify an Allocation port and a Redundant port, and create a NAS interface.
Configuration Details
-
Port Bonding
-
IP Address for Access
-
VLAN ID
Configuration Method
- 53 -