Chapter 3 Configuration; Setup Required In Advance; Checking Connection From Web Console - Fujitsu ETERNUS DX60 Operation Manual

Chapter 3
This chapter describes the configuration procedures of storage system operating environment by using Express.

3.1 Setup Required in Advance

In order to manage ETERNUS Disk storage system using Express, it is necessary to configure ETERNUS Disk storage system in advance.
Please set up the following item by using the ETERNUS Web GUI.
Refer to the ETERNUS Web GUI manuals for more information.
-
Check the IP address of the Management Server.
When the Management Server exists in a different subnet from where ETERNUS Disk storage system belongs, make sure that the
IP address of the Management Server is registered in "Access permission list for outside of the subnet" on "Setup environment for
network" screen. If it is not registered, register it.
-
On the following screens of the ETERNUS Web GUI, enable the SNMP function of MNT port:
Target Device
ETERNUS DX60 S3/DX100 S3/DX200 S3
ETERNUS DX200F
Other than that above
-
Check the ETERNUS Disk storage system name displayed in the Name column on the "Modify Storage System Name" screen.
When using Advanced Copy functions, specify 16 or less alphanumeric characters for ETERNUS Disk storage system name.
-
When you connect iSCSI, specify "Enable" the use of iSNS server in the target port.
For ETERNUS DX80 S2/DX90 S2, DX60 S3/DX100 S3/DX200 S3, ETERNUS DX200F, in addition to the above, execute the following
settings:
-
Create a new SSH server key.
Create an SSH server key on the following screens of the ETERNUS Web GUI. The number of bits for SSH server key is optional.
Target Device
ETERNUS DX60 S3/DX100 S3/DX200 S3
ETERNUS DX200F
Other than that above
-
Create a Software Role Account with the account information in the ETERNUS Web GUI "Setup User Account" screen.
Use this account information during the remaining of the procedure.
-
If a SNMP community name is not already set for ETERNUS Disk storage system, create the SNMP community name in the "Setup
SNMP Community" screen in the ETERNUS Web GUI.
Note
Make sure to logout from the ETERNUS Web GUI if the setting up is completed.

3.2 Checking Connection from Web Console

From the next section on, the described tasks are supposed to be performed from the Web Console.
Launch the Web Console and login, and then check that the initial screen is displayed.
Configuration
Screen Name
Setup SNMP Agent User
Setup SNMP Agent
Screen Name
Setup SSH Server Key
Create SSH Server Key
- 9 -