Stopping Sharing; Configuring Nas Backup - Fujitsu ETERNUS DX60 Operation Manual

When sharing is activated, it will be possible to access the shared folder via the NAS interface.
See
Refer to "Change NAS Interface" in the
Console.
4.6.4.8

Stopping Sharing

The sharing status of the shared folder will be stopped.
When sharing is stopped, it will not be possible to access the shared folder.
See
Refer to "Start/Stop Sharing" in the
4.6.4.9

Configuring NAS Backup

Configures the backup of NAS volume data.
For the NAS backup configuration, apart from creating a NAS backup volume, a copy group and copy pair will be configured.
If NAS backup is not set up, this function is enabled to create a NAS volume backup system.
Configure the following for the NAS backup volume:
-
NAS Backup Volume
-
Copy Group
-
Copy Pair
NAS Backup Volume
This is the volume for backup of the data of the NAS volume.
When there is no NAS backup volume, create a new NAS backup volume. Where there is a NAS backup volume, you can choose to
either create a new NAS backup volume or use an existing NAS backup volume.
The NAS backup volume is created with the following details.
Volume Name
Capacity
Volume Type
Thin Provisioning Pool of the Creation Destination
N " is a sequential number from 0. The number of digits varies.
*1: "
Point
For increased reliability, it is recommended to create Thin Provisioning Pools of the creation destination for the NAS backup volume
and the NAS volume in separate Thin Provisioning Pools.
Copy Group
This is a group for defining copy pairs of a NAS volume and a NAS backup volume.
If no copy group definition for backup exists, a copy group is automatically created with the following settings:
ETERNUS SF Web Console Guide for information on how to change NAS interface using the Web
ETERNUS SF Web Console Guide for information on the procedure using the Web Console.
nasVolumeName $bak_ N (*1)
Same as the source NAS volume
Same as the source NAS volume
User Selection
- 61 -