Fujitsu ETERNUS DX60 Operation Manual page 65

NAS Snapshot
Sets the number of generations that the NAS snapshot has and the snapshot capture schedule. This can be configured only when
setting a new NAS snapshot. When using an existing NAS snapshot, the existing setting is used. This cannot be modified.
Number of Snapshot Generations
Sets the number of snapshot generations owned.
However, the number of configurable generations differs according to the device model and firmware version number. Refer to
the NAS snapshot specification described in the manual accompanying the ETERNUS Disk storage system.
Schedule Configuration
Sets the snapshot capture schedule. The following items are set.
Item
Cycle Selects the cycle for capturing snapshots.
Daily: Snapshots captured every day at selected "Time".
Weekly: Snapshots captured on the selected "Day" and "Time" of every week.
Day Selects the days to capture the snapshot.
This cannot be selected when Daily is selected for the [Cycle].
Check the check box of the days you wish to capture the snapshot.
Time Selects the time to capture the snapshot.
Check the check box of the time you wish to capture the snapshot.
When an interval of capturing a snapshot is selected, the selected interval time is automatically
checked from the start point of zero time.
When configuring a new NAS snapshot, the NAS snapshot volume for the collected snapshot backup is automatically created. The
NAS snapshot volume is created with the following content.
Volume Name
Capacity
Volume Type
RAID Group Created
*1: " N " is a sequential number from 0. The number of digits varies.
Point
-
The snapshot is collected based on the time set for the ETERNUS Disk storage system.
-
When a new NAS snapshot is configured, it automatically goes into start state.
Note
When using the snapshot function, enable SNMP Trap Setup. If SNMP Trap Setup is not enabled, snapshot collection result is not
notified. Refer to "Change ETERNUS Disk Storage System Information" in the
change SNMP Trap Setup via the Web Console.
Access settings
Access Configurations of Shared Folder
The owner and group that will issue access rights in relation to the shared folder will be configured. For the owner and group,
configure a user or group on the authentication server configured with
Explanation
nasVolumeName $snap_ N (*1)
Same as the NAS volume of the backup source
SDV
User Selection
"4.6.3.3 NAS File System Environment
- 51 -
ETERNUS SF Web Console Guide for the procedure to
Settings". When root