Operation Adjust Menu Settings - Siemens FUG1010 IP65 NEMA 4X Operating Instructions Manual

Functions

7.10 Operation Adjust Menu Settings

Clearing Logger Memory
1. To access the [Clear Logger] option list press <Right Arrow>.
2. Move the cursor to [Yes] by pressing <Up/Down Arrow>.
3. To clear the memory press <ENTER>.
7.10 Operation Adjust Menu Settings
Introduction
The [Operation Adjust] menu becomes available after picking a meter type and
measurement channel. It is recommended that you use it after the sensors are installed and
operating to "fine-tune" the meter's output characteristics.
Each application presents different data display and output requirements due to unique pipe
and gas conditions. Use the [Operation Adjust] menu to match flow meter operation to the
site. You can set damping controls for the primary flow rate output. You can define a
Deadband, (usually a very low flow rate), below which the flow output will be forced to zero.
You can also select the flow meter response to a continuous Fault condition.
Damping Control
The flow meter provides two different data output filter types, Time Average and SmartSlew.
Time Average (recommended) integrates the instantaneous flow rate over a selectable time
period. Use the Time Average function when stability in flow reading is essential. A value
entered (in seconds) sets the time it takes the flow meter to respond to a rate change. The
default is 10 seconds. Enter any amount of time up to 60 seconds maximum.
SmartSlew performs data scatter damping during steady flow periods while maintaining the
ability to respond to changing flow rates. SmartSlew values range from [1 to 9]. Pick a higher
number to slow flow meter response to a rate change.
Setting the Time Average (default):
1. From the [Dual Path Flow] menu scroll to the [Operation Adjust] menu and press <Right
2. At the [Damping Control] menu press the <Right Arrow> and move the cursor down to
3. To enable Time Average entry press <Right Arrow>.
128
Arrow>.
[Time Average].
FUG1010 IP65 NEMA 4X
Operating Instructions, 01/2013, A5E02951519-AC