Siemens FUG1010 IP65 NEMA 4X Operating Instructions Manual page 20

FM-CSA installation
Read
equipm
installed according to the 1010-443 installation drawing prov
install the equipment in the prescribed manner will resu
jurisdictional safety codes when operating this equipme
equipment meets the following FM – CSA ratings:
Transmitter
● Explosionproof for Class I, Division1, Groups B, C, D;
● Dust-ignitionproof for Class II, Division 1, Groups E, F and G
● Intrinsically safe connections for Class I and II, Division 1, Groups A, B, C, D, E, F and G;
● Nonincendive for Class I, Division 2, Groups A,
● Suitable for Class II, Division
Sensors
● Intrinsically safe Class I and II, Division 1, Groups A, B, C, D, E, F and G;
● Nonincendive for Class I, Division 2, Groups A, B, C and D;
● Suitable for Class II, Division 2, Groups E, F and G outdoor (Type 4X), Class III (CSA
● Temperature code T6 at an ambient of 40°C
ATEX installation
Read, understand and follow all safety instruction on the electroni
equipment is rated for use in explosive atmospheres as stated b
according to the 1010-464 installation drawing provided on the media. Failure to install the
equipmen
laws when operating this equipment. When properl
following ATEX ratings as stated in EC-Type Exa
Transmitter Markin
●
●
●
● IP66 – Ingress protection against solid bodies, rating of dust-tight and against liquid,
FUG1010 IP65 NEMA 4X
Operating Instructions, 01/2013, A5E02951519-AC
, understand and follow all safety instruction on the electronic media provided. This
ent is rated for use in hazardous (classified) locations as stated below and must be
only)
only)
t in the prescribed manner will result in unsafe operation. Follow all regional safety
gs and Explanations
II (1) G [Ex ia] IIC– Transmitter located in the non-hazardous area with intrinsically
safe circuits of category Ex ia, which can be connected to Category 1 Sensors for use in
potentially explosive atmosphere containing gases
II 3 (1) G Ex nC [ia] IIC T5 (Tamb = 0° To + 60°C) – Category 3 Transmitter locate
Zone 2 potentially explosive atmosphere with intrinsically safe circuits of category Ex ia
which can be connected to Category 1 Sensors in Zone 0 potentially explosive
atmosphere containing gases
II 2 (1) G Ex d [ia IIC] IIB+H2 T5 (Tamb = 0° To + 50°C) – Category 2 Transmitter
locate d in Zone 1 potentially explosive atmosphere with intrinsically safe circuits of
category Ex ia, which can be connected to Category 1 Sensors for use in potentially
explosive atmosphere containing gases
rating of heavy seas
B, C and D;
2, Groups E, F and G outdoor (Type 4X), Class III (CSA
y installed the equipment meets the
mination Certificate KEMA03ATEX1134
2.5 Safety Notes
ided on the media. Failure to
lt in unsafe operation. Follow all local
nt. When properly installed the
c media provided. This
elow and must be installed
Safety notes
d in
,
19