Sony DVS-9000SF User Manual page 344

1
2
3
4
5
6
Modifying tally generation
Use the following procedure.
1
344
Setup Relating to Router Interface and Tally
In the Router/Tally>Tally Enable menu, press [New].
The New menu appears.
Turn the knobs to set the following parameters.
Knob Parameter
1 Destination Address
2 Destination Level
3 Tally Type
a) When you selected Group1 to 4 in the section "Setting the tally groups" (page 341), this is
1:R1, 2:G1, 3:R2, 4:G2, 5:R3, 6:G3, 7:R4, and 8:G4.
When you selected Group5 to 8, this is 1:R5, 2:G5, 3:R6, 4:G6, 5:R7, 6:G7, 7:R8, and
8:G8. (R is an abbreviation of "Red Tally," and G of "Green Tally.")
In the <Tally Enable> group, specify the tally generation mode.
Enable: Always generate a tally.
Disable: Never generate a tally.
Tally Input: Generate a tally from the tally input state.
When you selected Tally Input as the tally generation mode in step 3,
select any of the following in the <Tally Input> group.
DCU1: Generate tally with reference to signal input to DCU1 port. Set the
port number with the knob.
DCU2: Generate tally with reference to signal input to DCU2 port. Set the
port number with the knob.
Turn the knob to select the tally input port number.
Knob Parameter Adjustment
5 Input No Tally input port number
Press [Execute].
This sets the settings made in steps 2 to 5 as the settings for tally
generation.
In the Router/Tally>Tally Enable menu, press [Modify].
The Modify menu appears.
Adjustment
Destination address
Destination level
Tally type
Setting values
1 to 102
Setting values
1 to 1024
1 to 8
a)
1 to 8