Sony DVS-9000SF User Manual page 314

3
4
5
Setting the interface between the MVE-9000 and the switcher
Use the following procedure.
1
2
3
Setting the AUX bus output and reentry input
Select the signal input to the MVE-9000 (AUX bus output) and the signal
returned as the switcher primary input (reentry input) as follows.
314
Setup Relating to Switcher Processor
Remote4: Make the settings for the REMOTE4 port.
Using any of the following methods, select the AUX bus.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter Adjustment
1 No AUX bus selection
a) 0: EDIT PVW
1 to 48: AUX1 to AUX48
Select whether to enable or disable AUX bus control from the <Control
Mode> group.
Enable: enable control of the port selected in step 2.
Disable: disable control of the port selected in step 2.
Manual: make whether control of the port selected in step 2 is possible or
not depend on the setting in the Misc menu.
Repeat steps 2 to 4 as required to make the settings for other ports.
In the Engineering Setup menu, select VF3 'Switcher' and HF7 'Device
Interface.'
The Device Interface menu appears.
Press [DME Type Setting].
The DME Type Setting menu appears.
In the <DME1 Type> group to set DME1 or in the <DME2 Type> group
to set DME2, press [SDI], turning it on. ([Dedicated] is disabled.)
Dedicated: The MVE-9000 has an MVS-8000-series dedicated interface.
SDI: The MVE-9000 has an SDI interface.
Setting values
a)
0 to 48