Separate Sides Settings; Shaped Video Settings - Sony DVS-9000SF User Manual

3
Set the following parameters.
Knob
1
2
3

Separate Sides Settings

This effect applies separate video signals and key signals to the front and back
of the image.
For an illustration of the concept of front and back, see "DME Special Effects"
in Chapter 1 (Volume 1).
Applying the Separate Sides effect
Use the following procedure.
1
In the DME menu, select VF6 'Input/Output' and HF2 'Video/Key.'
The Video/Key menu appears.
2
Press [Separate Side], turning it on.
The Separate Sides effect is enabled. If the video and key signals currently
being output to the monitor are the front side, you can select the front
signals. If they are the back side, you can select the back signals. Video and
key signals are selected with the cross-point control blocks of each M/E
bank or the PGM/PST bank.

Shaped Video Settings

Switching shaped video on or off
When the DME being used is the MVE-9000, you can select whether or not the
following signals are treated as shaped video (a signal subjected to key
processing).
• The input video signal from the switcher, for each of the front and back sides
of an image
• The output video signal
Use the following procedure.
Parameter Adjustment
Luminance Luminance
Saturation Saturation
Hue Hue
Setting values
0.00 to 100.00
0.00 to 100.00
359.99 to 0.00
DME Special Effect Operations
111