Sony DVS-9000SF User Manual page 280

7
Test firing the trigger
To test fire the trigger, press [Test Fire].
This outputs a trigger from the selected output port. This is not output when the
trigger type is "Status."
Setting the control mode for P-BUS devices
In the <P-Bus Control> group of the Panel>Device Interface menu, select the
mode.
Trigger: When a predetermined button is pressed, the action command
Timeline: The external device is controlled as a keyframe effect controlled by
Making DCU serial port settings
You can assign buttons in the device control block (DEV1 to DEV12) to DCU
serial ports, to operate the devices (disk recorder/VTR) connected to these
ports. For a disk recorder, you can also set the sharing of file lists.
For details of DCU serial port settings, see "Serial Port Settings (Serial Port
Assign Menu)" (page 331).
To associate a serial port with a device selection button
1
2
280
Setup Relating to Operations From the Control Panel
When Source is Common: KF Run, No Action
• Action list when the trigger type is "Status"
When Source is M/E-1, M/E-2, or M/E-3: Key1 SS ? Recall, Key2 SS ? Recall, Key3
SS ? Recall, Key4 SS ? Recall
Key1 On, Key2 On, Key3 On, Key4 On, No Action
When Source is P/P: DSK1 SS ? Recall, DSK2 SS ? Recall, DSK3 SS ? Recall, DSK4
SS ? Recall
DSK1 On, DSK2 On, DSK3 On, DSK4 On, No Action
When Source is Common: Error Make, Error Break, No Action
b) When knob 2 selection is "Key Snapshot"
Press [Action Set] to confirm the action selection.
The selected setting appears in the status area.
assigned to that button is output, to control an external device.
the center control panel.
In the Panel>Device Interface menu, press [DCU Serial Port Assign].
The Serial Port Assign menu appears.
Using any of the following methods, select the DCU serial port.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.