Sony DVS-9000SF User Manual page 184

4
Changing the path type for Hue
Use the following procedure.
1
2
Changing the path type for Xpt
Use the following procedure.
1
184
Path Setting
At this point, depending on the setting for Curve, the effect for Hue and
Xpt is also affected as shown in the following table. In the menu, the Hue
and Xpt settings do not change, but the path type indication is dimmed out.
Curve setting Hue change
OFF Does not change
Step Changes as with the Step setting
If you selected Spline as the path type, set the following parameters, using
the knobs.
Knob Parameter
1 Tens
2 Bias
3 Cont
Press the Hue path type indication for the item that you want to change.
Turn knob 1 to change the Hue path type.
The path type indications shown in the menu represent the change in hue
as seen on a Vectorscope.
CW: Rotate clockwise.
CCW: Rotate counterclockwise.
Short: The hue changes in whichever of the clockwise and
counterclockwise directions is shorter.
Long: The hue changes in whichever of the clockwise and
counterclockwise directions is longer.
Press the Xpt path type indication for the item that you want to change.
A path selection window appears.
Adjustment
Spline interpolation tension
Spline interpolation bias
Spline interpolation continuity
Xpt change
Hold
Is not affected
Setting values
–4.00 to +4.00
–4.00 to +4.00
–4.00 to +4.00