Executing A Macro By Macro Attachment - Sony DVS-9000SF User Manual

background A row button that is flashing. The button for which a macro
attachment was set stops flashing and goes off, and the setting is canceled.
To remove all macro attachment settings in a single operation
You can remove all macro attachment settings in a single operation. Use the
following procedure.
1
In the Macro menu, select VF2 'Attachment.'
2
Press [All Clear].
A confirmation message appears.
3
Select [Yes].
This deletes all macro attachment setting data.

Executing a Macro by Macro Attachment

Note
To carry out this operation, it is first necessary to assign the "MCRO ATTCH
ENBL" function to the user preference buttons in the menu control block or the
utility/shotbox control block. Carry out this assignment in the Eng
Setup>Panel>Prefs/Utility menu. (For details, see "Setting Button
Assignments (Prefs/Utility Menu)" (page 266).)
Use the following procedure.
1
Press the [MCRO ATTCH ENBL] button assigned to a utility/shotbox
control block button or user preference button, turning it on.
2
Press the desired button for which a macro attachment has been set.
This recalls the macro register assigned to the button, and the macro is
executed as follows, according to the operation mode.
Pre macro mode: The macro is executed first, and then the button
function is executed.
Post macro mode: The button function is executed first, and then the
macro is executed.
Macro only mode: The button function is not executed, and the macro
only is executed.
Macro Attachment Assigning
385