Sony DVS-9000SF User Manual page 311

b) When knob 3 selection is "Key Snapshot"
c) When knob 3 selection is "Snapshot" or "Effect"
6
Press [Action Set] to confirm the action selection.
The selected setting appears in the status area.
Carrying out level settings
To set the low level and high level, first set the trigger type to "Level," then use
the following procedure.
1
In the Switcher>Device Interface menu, select the action to be set, and
press [H/L Set].
The H/L Set menu appears.
2
Using any of the following methods, select the settings.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob
1
3
To apply the selection made in step 2 when the input is high, press [H Set].
To apply the selection made in step 2 when the input is low, press [L Set].
This confirms the setting, which appears in the status area.
Note
When the action is "Format," these settings conflict with the current
settings, but after making the settings, agreement is restored after a pulse
change or power off/on.
Making switcher processor GPI output settings
Use the following procedure.
1
In the Switcher>Device Interface menu, press [GPI Output].
The GPI Output menu appears.
If a GPI to switch "Aspect" or "Format" occurs when powering the system off, the
action triggered by the GPI may start immediately before the power goes off and the
power may go off before the action is completed. This may corrupt the setup settings.
It is therefore recommended to use "Level Enable" to avoid such a situation.
Parameter Adjustment
No Signal format/screen aspect ratio
selection
Setting values
1 to ...
Setup Relating to Switcher Processor
311