NEC Univerge SV9100 Installation Manual page 42

Once the license has been installed then the feature has to be enabled and configured, this is done in
Tools > Options > Server > PCI Compliance.
The settings are described in the table below:
Option
Detect DTMF
commands
Start Recording
command (Agent)
Stop Recording
command (Agent)
Start Recording
command (Customer)
Stop Recording
command (Customer)
DTMF Detection
interval (seconds)
Restart recording
timeout
Function
Check the box to enable the feature.
This is the DTMF sequence used by a user on the PBX to
again after it has been stopped. Enter # or * and a digit(s) as required.
This is the DTMF sequence used by a user on the PBX to
Enter # or * and a digit(s) as required.
This is the DTMF sequence used to start recording again after it has
been stopped by the outside caller. Enter # or * and a digit(s) as
required.
This is the DTMF sequence used by the outside caller to
Enter # or * and a digit(s) as required.
The number of seconds between dialling the first and last digits to pause
recording. If the DTMF digits are spread over a longer interval, the
sequence will not be detected. The max value is 15 seconds.
Set the maximum duration not to record in seconds. When recording
has been paused it will automatically restart after this timer expires. If
the value is set to 0 then recording will only restart when the start
command is sent again.
start recording
stop recording.
stop recording.
42 | P a g e