Cisco D9865 Installation And Operation Manual page 53

Selection
LO Select
(Sets a 22 kHz tone
for Ku-band dual
LNB)
LO Freq 1
LO Freq 2
Crossover
LNB Power
(For more
information, see
LNB Power
Settings, on
page 4-25.)
DiSEqC
DiSEqC Switch
4035197 Rev C
Options
On Switches 22 kHz tone on.
Off Switches 22 kHz tone off.
Auto Sets 22 kHz tone to automatic.
If Downlink Freq < Crossover, use LO
Freq 1. The 22 kHz tone is Off.
If Downlink Freq > Crossover, use LO
Freq 2. The 22 kHz tone is On.
Enter If C-band application, set to 5.15 GHz
number (default).
If Ku-band single LNB, enter LO Freq. and
set LO Freq 2 and Crossover to 0.0.
If Ku-band dual LNB, enter LO Freq 1, LO
Freq 2 and Crossover.
Enter Enter if Ku-band dual LNB application.
number LO Freq 2 > LO Freq 1.
Enter Enter if Ku-Band dual LNB application.
number Determines if LO Freq 1 or LO Freq 2 is
used for tuning.
18-H For H polarization (18V).
13-V For V polarization (13V).
Off Use for external LNB power.
Note: LNB power must be on if DiSEqC is
required.
H-NIT Initially applies the horizontal
polarization voltage, and then follows the
polarization based on the NIT.
V-NIT Initially applies the vertical polarization
voltage, and then follows the polarization
based on the NIT.
Enable Enables or disables Digital Satellite
Equipment Control. This must be enabled
Disable
to control the DiSEqC switch. LNB Power
must be on to use this setting. Refer to
http://www.eutelsat.com/satellites/
4_5_5.html
Off Selects a port on the LNB switch (if used). Off
A to P
D9865 Satellite Receiver Installation and Operation Guide
Description
for more information.
Default
Off
10.75 GHz
0.0
0.0
18-H
Disable
4-19