Cisco D9865 Installation And Operation Manual page 83

Changing the Lock Level Password,
Performing a Factory Reset
The Factory Reset (F/R) is used for restoring the receiver's factory presets (defaults).
When activated, the current receiver settings are replaced by the default settings.
After the factory defaults are restored, you can change the receiver settings as
required.
To restore the factory default settings using the remote control:
1. From the Advanced Administration screen, press the blue button (F/R).
2. Select Yes to reset the receiver and restore to factory defaults. Select No to cancel
the operation.
Following a factory reset, the receiver returns to Standby mode. Wait for the
flashing front panel LED, and then press the Display button on the remote control
or front panel, followed by the Menu button to return to the Main Menu.
Rebooting the Receiver
If you need to reboot the receiver for any reason, you can perform this function
without changing any settings.
To reboot the receiver:
1. From the Advanced Administration screen, press the yellow button (Reboot). A
message appears confirming that you want to reboot the receiver.
2. Select Yes to reboot. Otherwise, select No.
Resetting the Web GUI Login Information
The Reset Login (RstLogin) is used for resetting the username and password used
for Web GUI login to its default values. The default username is admin and the
default password is localadmin.
To reset the login:
1. From the Advanced Administration screen, press the blue button (RstLogin). A
message appears confirming that you want to reset the password to its default
values.
2. Select Yes. Otherwise, select No.
4035197 Rev C D9865 Satellite Receiver Installation and Operation Guide
Continued
4-49