Cisco D9865 Installation And Operation Manual page 131

Configuring Tuning Setup,
12. The Current Input Status section displays the current RF status. The following
table describes the Current Input Status information displayed:
Downlink Frequency
L Band Frequency
(MHz)
Symbol Rate (Msym)
FEC
Modulation Type
Pilots
I/Q
Signal Status
TS ID
LNB Presets
Acquisition State
13. Click Apply.
4035197 Rev C
Continued
RF Status
Indicates the current downlink frequency, in GHz.
Indicates the current L-Band frequency, in MHz.
Indicates the Symbol Rate of the received signal, in
MS/s.
Indicates the FEC (Forward Error Correction) rate of
the received signal.
Indicates the modulation type for the received
signal.
Indicates whether the pilots for the DVB-S2
modulation is on or off.
Indicates the input signal spectrum inversion
setting.
Indicates the current signal lock status for the input.
Locked - Receiver is locked to a carrier with no valid
content.
Lock+Sig - Receiver is locked to a carrier with valid
content.
No Lock - Receiver is not locked to a carrier.
Displays the Transport Stream ID.
Indicates the number of LNB presets configured.
Displays Full if the ASI and PSI tables have all been
found. Otherwise, it will display Degraded if there
are missing tables or None if no ASI or PSI tables
have been found.
D9865 Satellite Receiver Installation and Operation Guide
Description
5-11