Configuring Time/Clock Information - Cisco D9865 Installation And Operation Manual

Configuring Time/Clock Information

To Configure the Time/Clock Settings
Proceed as follows to configure the time/clock settings of the D9865 satellite
receiver:
1. From the user interface of the D9865, click System Settings > System > Time/
Clock. The Time/Clock page is displayed.
2. Set the Date Format of the receiver. The following formats are supported:
YYYY/MM/DD, DD/MM/YYYY, MM/DD/YYYY.
3. Set the Time Format of the receiver. Time information is normally broadcast as
part of the transmitted digital signal. It is usually the broadcaster local time
relative to Greenwich Mean Time (GMT). The following formats are supported:
24 Hr, 24 Hr SuspendZero, 12 Hr, 12 Hr SuspendZero.
4. Set the GMT Time Offset. The time is displayed using a time zone instead of
the true local time. If the current broadcast time is not your local time, you must
change this time setting in the range from -12:00 to +13.00 in one hour
increments.
5. The Current Time displays the current date and time, according to the date and
time formats set.
6. Click Apply.
5-50 D9865 Satellite Receiver Installation and Operation Guide 4035197 Rev C