Notes On Cleaning Agents; Resetting The Maintenance Indication - Nordmann AT4 Operating Instructions Manual

6.5

Notes on cleaning agents

6.6

Resetting the maintenance indication

After completing maintenance work, the maintenance indication (yellow LED lights) must be reset:
1. Select the maintenance menu:
Path: Main menu > User > Password: 3562 > Maintenance
AT4 130kg/h 400V3
Standby
2011-08-31 12.00.00
Menu
2. Select "Cyl. A Reset" (or "Cyl. B Reset"), then press the <Set> key.
3. The reset dialogue appears in the display. Press the <Yes> key to reset the maintenance counter
or the maintenance indication respectively. The maintenance counter and the maintenance
indication are reset and the control unit is restarted.
Note: by pressing the <No> key the reset procedure can be aborted and the display and control
unit returns to the maintenance menu. To return to the standard operating display press the <Esc>
key several times.
58
Only use cleaning agents stated in the table above. the use of disinfect­
ants is only permitted if they do not leave any toxic residues. In any case
the parts must be thoroughly rinsed with water after cleaning.
WARNING!
Formic acid is indeed harmless to the skin, but it attacks the mucous
membranes. Therefore prevent your eyes and respiratory tracts from
getting in touch with the acid and its vapours (wear goggles and work in
a well ventilated room or outside).
CAUTION!
Do not use any solvents, aromatized or halogenized hydrocarbons
or other aggressive substances as they may cause damage to the
components of the unit.
It is mandatory to observe and comply with the information and instructions
regarding cleaning agents. Observe in particular: all information relating
to the protection of personnel, environmental protection and restrictions
regarding usage.
Main Menu User
User :Set Maintenance :Set
Engineering :Set Settings
Diagnostic :Set Modbus
Esc Set Esc
User Code
3562
Enter Number
Confirm with Set
Esc Set
Maintenance
HistoryReset:Set
:Set Cyl. A Reset:Set
:Set Cyl. B Reset:Set
Set Esc
Cyl. A Reset
Attention !
without cyl. Mainten.
is very dangerous!
Are you sure?
No Yes
AT4
STARTUP:
INIT MODULE
Set
Reset