Working With The Unit Control; Factory Settings - Nordmann AT4 Operating Instructions Manual

5

Working with the unit control

5.1

Factory settings

Designation
Dialogue language
Controller settings
Signal source
Control type
Control signal
Supply air limitation
Cylinder type
sc system
status sc pump
Operating time of the sc pump per hour
Capacity limitation
Set capacity limitation
Time control capacity limitation
Timer controlled operation of the humidifier
Time control operation
Water management
Water conductivity
Drain factor
Operating behaviour in idle mode
status forced draining function
Time delay forced draining
Date
time of day
Display contrast
Note: if you are working with the optional remote terminal read chapter
5.7 "Working with the remote terminal" first. the operation of the remote
terminal deviates in some points from the operation at the humidifier and
some adjustments are blocked via the remote terminal for safety reasons.
Ex works the unit control is set to the following standard settings:
See chapter Parameter
5.4.2 Language
5.4.3
SignalSource
Hum.Control
Controlsign.
Lim. Control
5.4.4 Cylinder
5.4.5
SC-Pump
On-Time
5.4.6
Power Limit
Timer
5.4.7
Timer
5.4.8
Conductivity
Drain Factor
Idle Mode
Force Drain
Force Delay
5.4.9 Date
5.4.10 Time
5.4.11 Contrast
Factory setting
country specific
Analog
Extern
0-10V
Off
unit specific
On
unit specific
100 %
Off
Off
>125 µS/cm
1.0
IdleOnly
On
72 hours
to be set on site
to be set on site
50
21