Setting The Time Of Operation After Which A; Setting The Date; 5.4.10 Setting The Time; Setting The Display Contrast - Nordmann AT4 Operating Instructions Manual

5.4.8.5 Setting the time of operation after which a forced draining takes place
Select "Force Delay" in the water management settings submenu, then press the <Set> key.
Settings
Power Limit :Set
On/Off Timer :Set
Water Manag.:Set
Date :11-08-31
Time :12:00
Esc
In the upcoming modification dialogue set the time of operation after which a forced draining takes
place.
Factory setting:
Setting range:
5.4.9

Setting the date

Select "Date" in the settings menu, then press the <Set> key.
Settings
On/Off Timer :Set
Water Manag.:Set
Date :11-08-31
Time :12:00
Contrast :50
Esc
In the upcoming modification dialogue set the actual date (format:"yyyy.mm.dd").
5.4.10 Setting the time
Select "Time" in the settings menu, then press the <Set> key.
Settings
On/Off Timer :Set
Water Manag.:Set
Date :11-08-31
Time :12:00
Contrast :50
Esc
In the upcoming modification dialogue set the actual time (format:"hh.mm").
5.4.11

Setting the display contrast

Note: this function is not available via the optional remote terminal.
Select "Contrast" in the settings menu, then press the <Set> key.
Settings
On/Off Timer :Set
Water Manag.:Set
Date :11-08-31
Time :12:00
Contrast :50
Esc
In the upcoming modification dialogue set the desired value for the display contrast.
Factory setting:
Setting range:
Water Manag.
Conductivity:>125µS
Drain Factor:1.0
Idle Operat.:Set
Force Drain :On
Force Delay :72h
Set Esc Set
72 hours
1...720 hours
Date
2011-08-31
2011-08-31
Set Esc Set
Time
12:00
12:00
Set Esc Set
Contrast
50
50
Set Esc Set
50
25 (light) ...80 (dark)
Force Delay
72 h
72 h
Esc Set
37