Should you have any queries that go beyond the scope of these operating instructions, please contact the company from which you have purchased the humidifier or which has installed it. As the manufacturers, we are, of course, always ready to be of assistance, since we want all our customers to be completely satisfied with our products.
All installation and service work must be done only by persons qualified to perform such work. Proper use The steam humidifier econoVap is intended solely for indirect or direct air humidification according to this manual. Used in any other way beyond this description is contrary to its intended usage.
Dimensions of the steam distribution pipes Type A (mm) B (mm) C (mm) 22-300 Ø 22 22-450 Ø 22 22-650 Ø 22 22-850 Ø 22 35-300 Ø 35 35-450 Ø 35 35-600 Ø 35 35-900 Ø 35 35-1200 1200 Ø 35 35-1500 1500 Ø...
Page 6
Dimensions of the steam blowers 4-23 kg/h Fig. Type 3.10 4–8 kg/h 3.11 15–23 kg/h Fixing holes for the steam blowers 4-23 kg/h Type 4 - 8 kg 15-23 kg Fig. 3.9 Dimensions of the Turbo steam blowers 32, 45 und 65 kg/h Fig.
3.3 Fitting the humidifier For the fitting of the humidifier use the material supplied with the unit. Observe the various minimum distances as indicated in figure 3.5. Ensure that there is sufficient room to perform servicing and maintenance work and that the unit is easily accessible.
Fig. 3.21 3.5 Fitting the blowers For the humidifier to work best, correct steam distribution is essential. For this reason, the minimum distances must be observed when installing the equipment. Please note that only wall installation is possible with the econoVap.
Technical specifications steam blowers: Max. steam Air volume output 4–8 kg/h 15–23 kg/h 32 kg/h 45–65 kg/h 3.6 Laying the steam hose The steam hose should be kept as short as possible. It should not be possible to block or obstruct the steam supply lines in any way.
If the steam-distribution pipe is fitted above the humidifier, the condensate can be fed back to the unit by placing the end of the hose in the filling cup.
Please observe the local regulations concerning the connection of appliances to the pressure and drainage system. The humidifier is designed to operate on ordinary tap water only. If you intend to use treated or de-mineralised water, consult your NORDMANN representative beforehand.
Fig. 6.1 6.3 LED Display The electronic controls unit of the econoVap monitors the operation of the humidifier continuously. All operating conditions and system indications are shown with the two-colour LED. The status of the LED can be shining continuously or flashing in the red and green colours.
Because the electrodes are then in contact with less water, current consumption falls back to the nominal value. If the current fails to fall below 140 % of the nominal level even after several drainage operations, the humidifier turns itself off automatically and the failure message “U2” (continuously red) appears on the LED display.
• Inspect the drainage cup. Clean or replace if necessary. 7.2 Rectifying faults The humidifier produces insufficient or no steam. Following causes are possible: • The humidity controller is not demanding any steam production. • There is no water in the steam cylinder because the water supply is interrupted.
7.4 Taking the humidifier out of operation If the humidifier is out of operation for a longer period of time ( e.g. in summer or when the air conditioning system is not operating), the steam cylinder must be emptied and the power supply disconnected.
9. Technical specifications Type mark: Type Heating voltage Volt Number of phases Heating current External fuses p. phase Type mark: Type Heating voltage Volt Number of phases Heating current External fuses p. phase Steam output kg/h Minimum capacity kg/h steam Nominal power Design data: Dimensions...
Need help?
Do you have a question about the 2401935EN0801 and is the answer not in the manual?
Questions and answers