Table of Contents
Advertisement
Cleaning the motorcycle
To preserve the finish of metal parts and paintwork,
wash and clean your motorcycle at regular intervals,
anyway according to road conditions. Use specific
products only. Prefer biodegradable products. Avoid
aggressive detergents or solvents.
Use only water and neutral soap to clean the Plexiglas
and the seat.
Periodically clean by hand all aluminium components.
Use special detergents, suitable for aluminium parts.
Do NOT use abrasive detergents or caustic soda.
Note
Do not use sponges with abrasive parts or steel
wool: only use soft cloths.
However, the warranty does not apply to motorcycles
whenever poor maintenance status is ascertained.
240
Important
Do not wash your motorcycle right after use.
When the motorcycle is still hot, water drops will
evaporate faster and spot hot surfaces.
Never clean the motorcycle using hot or high-
pressure water jets.
Cleaning the motorcycle with a high pressure water
jet may lead to seizure or serious faults in forks, wheel
hubs, electric system, headlight (fogging), fork seals,
air inlets or exhaust silencers, with consequent loss
of compliance with the safety requirements.
Clean off stubborn dirt or exceeding grease from
engine parts using a degreasing agent. Be sure to
avoid contact with drive parts (chain, sprockets, etc.).
Rinse with warm water and dry all surfaces with
chamois leather.
Warning
Braking performance may be impaired
immediately after washing the motorcycle. Never
grease or lubricate the brake discs to avoid losing
braking power. Clean the discs with an oil-free
solvent.
Advertisement
Table of Contents
