Table of Contents
Advertisement
Note
When the LAP function is active, the FLASH
button takes on the dual function of high beam
"FLASH" and LAP timer start / stop (new lap start
indication).
Note
The TRIP FUEL function always has top priority
over the LAP function: in case of activation of the
TRIP FUEL function with active LAP function, the LAP
timer view is automatically removed and TRIP FUEL
information is displayed instead.
LAP recording
If the LAP function is active, it is possible to record the
lap time, for a total of 30 consecutive laps.
Operation:
-
When the FLASH button (3) is pressed for the
first time, or upon an equivalent command
(optional GPS), the instrument panel displays the
timer with resolution of a tenth of a second
("0'00''0");
-
the next times the FLASH button (3) is pressed,
or after an equivalent control (optional GPS), the
instrument panel displays for 5 seconds the just-
ended lap time with a resolution of a hundredth of
a second;
-
after these 5 seconds, the instrument panel goes
back to lap timer page referred to the new current
lap.
-
if motorcycle remains at standstill for over 5
seconds, lap timer is temporarily stopped and it is
displayed with the initial indication "0'00''00";
-
the next time rider pushes the FLASH button (3)
or any equivalent command (optional GPS), lap
timer is reactivated.
If the time is never stopped, it will roll over upon
reaching 9 minutes, 59 seconds and 99 hundredths;
the lap timer starts counting from zero and will keep
running until the lap is stopped or the recording
function is disabled.
Laps are numbered from 01 to 30 and are in a loop:
after the first 30 laps the instrument panel will
overwrite information starting from Lap 01.
If the LAP function is interrupted and then reactivated
but memorised laps are not deleted, lap information
will be recorded by overwriting data of the oldest Lap.
81
Advertisement
Table of Contents
