Table of Contents
Advertisement
Cleaning the motorcycle
Note
To preserve the finish of metal parts and
paintwork, wash and clean your motorcycle at
regular intervals, anyway according to road
conditions. Use specific products only. Prefer
biodegradable products. Avoid aggressive
detergents or solvents.
Use only water and neutral soap to clean the
Plexiglas and the seat.
Periodically clean by hand all aluminium
components. Use special detergents, suitable for
aluminium parts. Do NOT use abrasive detergents or
caustic soda.
Note
Do not use sponges with abrasive parts or steel
wool: only use soft cloths.
However, the warranty does not apply to
motorcycles whenever poor maintenance status is
ascertained.
Important
Do not wash your motorcycle right after use.
When the motorcycle is still hot, water drops will
evaporate faster and spot hot surfaces.
Never clean the motorcycle using hot or high-
pressure water jets.
Cleaning the motorcycle with a high pressure water
jet may lead to seizure or serious faults in forks,
wheel hubs, electric system, headlight (fogging),
fork seals, air inlets or exhaust silencers, with
consequent loss of compliance with the safety
requirements.
Clean off stubborn dirt or exceeding grease from
engine parts using a degreasing agent. Be sure to
avoid contact with drive parts (chain, sprockets, etc.).
Rinse with warm water and dry all surfaces with
chamois leather.
Attention
Braking performance may be impaired
immediately after washing the motorcycle. Never
grease or lubricate the brake discs to avoid losing
braking power. Clean the discs with an oil-free
solvent.
283
Advertisement
Table of Contents
