Configuring Date And Time Settings; Date And Time Settings Screen - Dell PowerVault TL1000 User Manual

3. Encryption policy (library-managed encryption)
v Encrypt All (default) - All tape cartridges that are loaded into the tape drive are encrypted.
v Internal Label - Selective Encryption - This option is used only for Symantec's Veritas NetBackup.
v Internal Label - Encrypt All - This option is used only for Symantec's Veritas NetBackup.
4. Security (library-managed encryption) - Sets secure communications with secure sockets layer (SSL).
v Enable SSL for EKM - Select to enable secure SSL communications between the tape library and
the EKM server.
5. Primary EKM Server Settings and Secondary EKM Server Settings (library-managed encryption) -
For encryption to work, at least one server must be configured with an IP address and port number.
v IP address - The IP address of the encryption key manager. IPv4, IPv6, and dual stack IPv4/IPv6
are supported.
v TCP port number - The TCP port number of the encryption key manager.
v SSL port number - The port number of the encryption key manager.
To determine whether a cartridge is encrypted, use Configure Library > Library Map and select the
cartridge. The screen displays whether the cartridge is encrypted, not encrypted, or unknown.
Click Submit to transfer the settings to the library. A dialog message is displayed when the settings are
updated successfully.

Configuring date and time settings

Figure 94. Date and time settings screen
Select Configure Library > Date and Time to configure the date and time settings with one of three
methods. The date and time can be automatically updated with a remote NTP time server over the
network. Alternatively, the date and time can be synchronized with the clock on your host computer. And
lastly, that date and times can be set manually.
Note: Selecting Refresh refreshes the date and time.
Note: If you choose to manually set your date and time, you must reset the date and time after the
library is power cycled and after a library reset.
Note: When the library is power cycled, wait 10 seconds after the power is OFF before powering ON the
library again.
The TL1000 Tape Autoloader communicates with an NTP server with the following conditions:
v Client/server basis operation
v UDP (User Datagram Protocol) to access the NTP server
v Does not use authentication keys
v Library polling is every 12 hours
79
Operations