Trap List Settings; Snmpv3 User List Settings - Dell PowerVault TL1000 User Manual

Figure 40. Trap list settings
v Validity - Enable/Disable setting.
v Trap version - v1, v2c, or v3. For v2c and v3, the Inform check box determines whether an SNMP
INFORM request is sent instead of a trap event.
v IP address - IPv4 and IPv6 addresses are supported. Host names can be entered instead of
numerical IP addresses if the DNS server is specified.
v Community (v1 or v2c) - SNMP community name.
v User name (v3 only) - SNMPv3 unique user name.
v Authentication (v3 only) - Authentication algorithm, MD5, or SHA. When an algorithm is specified,
an authentication password and confirmation of the password are required.
v Privacy (v3 only) - Privacy service encryption and decryption algorithm, DES or AES. When an
algorithm is specified, a privacy password and confirmation of the password are required.
6. Enter the SNMPv3 users who are allowed to access the tape library in the SNMPv3 User List menu.
Figure 41. SNMPv3 user list settings
v Validity - Enable/Disable setting.
v User name - SNMPv3 unique user name.
v Authentication - Authentication algorithm, MD5, or SHA. When an algorithm is specified, an
authentication password and confirmation of the password are required.
v Privacy - Privacy service encryption and decryption algorithm, DES or AES. When an algorithm is
specified, a privacy password and confirmation of the password are required.
7. Select the event level to report in the Trap event field.
8. Click Test to send a test trap notification to the enabled IP addresses.
42
Dell PowerVault TL1000 Tape Autoloader: User's Guide