Table of Contents
Advertisement
– IPv6 - Select to enter four library IP addresses with the IPv6 protocol.
v Subnet Mask - If DHCP is disabled, set the IP address of the subnet mask.
– Subnet Mask - Select to enter the subnet mask address with the IPv4 protocol.
– Prefix Length - Select to enter the prefix length for the IPv6 protocol.
v Gateway - If DHCP is disabled, set the IP address of the gateway.
– IPv4 - Select to enter the gateway IP address with the IPv4 protocol.
– IPv6 - Select to enter four gateway IP addresses with the IPv6 protocol.
Configuring Operator Panel settings
Figure 69. Operator Panel settings
Select Configuration > Configure Op Panel Settings to set the preferences when with the Operator
Panel.
Configure the Operator Panel with the following settings:
v Back light - Select to enable the LCD back light when with the Operator Panel.
– Input Count - If the auto back light is enabled, specify the time duration before the back light turns
OFF. The setting uses a four-digit timer in minutes.
v Login Password - Select to change the Operator Panel four-character login password. The new
password must be reentered for confirmation before the password is changed (default: 0000).
Configuring Web GUI Settings
Figure 70. Configuring Web GUI settings
Use Configuration > Configure Web GUI Settings > Unlock a User Account to unlock a User Account.
The password of the user unlocked by Unlock a User Account is automatically changed to secure.
62
Dell PowerVault TL1000 Tape Autoloader: User's Guide
Configuration
Configure Op Panel Settings
Configure LCD Back Light
Enable Auto Back Light
Input Count (min)
Disable Auto Back Light
Change Login Password
New Password
Reenter Password
Configuration
Configure WEB GUI Settings
Unlock a User Account
Advertisement
Table of Contents
