Dell PowerVault TL1000 User Manual page 48

Table 13. Default library configuration settings (continued)
Configuration Item
Static IP address
IPv6 address
Prefix length
Gateway
DNS setting
DNS IP address
Library name
Auto Cleaning
Bar code label length
Library mode
Loop
Auto Load
Active slots
Encryption method
NTP server
NTP server address
Time zone (GMT)
Date (MM/DD/YYYY)
Auto adjustment by PC
SMTP (mail) settings
Mail server address
Mail event
SNMP (trap) settings
Community
Trap event
SNMPv3 engine ID
Static library network settings must be entered with the Operator Panel before the library can be accessed
remotely with the Web User Interface. If your system is serviced by a Dynamic Host Configuration
Protocol (DHCP) server, the network parameters are automatically set. Once remote access is established,
you can complete the configuration of your library remotely.
If you choose to use the Operator Panel to configure your library, go to "Configuring your library with
the Operator Panel" on page 45.
30
Dell PowerVault TL1000 Tape Autoloader: User's Guide
PHYSICAL
LOGICAL
ENCRYPTION
DATE and TIME
NOTIFICATIONS
Default Setting
Disabled
0:0:0:0:0:0:0:0
64
0:0:0:0:0:0:0:0
Disabled
0.0.0.0
(Blank)
Disabled
8 characters
Random
Enabled
Enabled
9 + 0
None
Disabled
0.0.0.0
+00:00
01/08/2008
Every 1 minute
0.0.0.0
Error events enabled
Public
Error events enabled
(Set by library firmware)