Table of Contents
Advertisement
Slide Rack Mount Kit (XBR-R000070)
3.
Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs (29 cm-kgs).
FIGURE 12 Attaching the rear bracket to the rack post
1.
Bracket, front right
2.
Bracket, rear right
Slide Rack Mount Kit (XBR-R000070)
Use the following instructions to install a 1U or 2U device in a 19-in. (48.3 cm) EIA rack using the Slide Rack Mount Kit. Round-hole
and square-hole rack posts are supported.
Observe the following when mounting this device:
•
The device can be installed so that the port side is either flush with the front posts or recessed from the front posts. A recessed
position allows a more gradual bend in the fiber optic cables connected to the device.
•
Use Electronic Industries Association (EIA) standard racks. Provide space in a 19-in. (48.3 cm) EIA rack, as required for the
device type, with a minimum distance of 28.25 in. (71.76 cm) and a maximum distance of 29.88 in. (75.90 cm) between the
front and back posts.
•
Two people are required to install the device in a rack. One person holds the device, while the other secures the device to the
rack.
•
Hardware devices illustrated in these procedures are only for reference and may not depict the device you are installing into the
rack.
34
3.
Retainer nut, 10-32
4.
Screw, 10-32 x 5/8-in., panhead Phillips
Brocade G610 Hardware Installation Guide
53-1004408-08
Hide quick links:
Advertisement
Table of Contents
