Attaching The Rear Brackets To The Front Brackets - Brocade Communications Systems G610 Hardware Installation Manual

3. Attach the left front bracket to the left front rack post using two 10-32 x 5/8-in. screws and two nuts and tighten all 10-32 x
5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 33 Positioning the device in the rack
1. Screws, 10-32 x 5/8 in., panhead Phillips
2. Retainer nuts, 10-32, square or round hole as needed

Attaching the rear brackets to the front brackets

NOTE
The rear brackets in the kit are also labeled UP with an upward pointing arrowhead to reduce confusion in mounting.
Complete the following steps to attach the rear brackets to the front brackets.
1. Position the right rear bracket inside the right front bracket.
2. Attach the brackets using four 6-32 x 1/4-in. screws as shown in the following figure.
3. Adjust the brackets to the rack depth and tighten the 6-32 x 1/4-in. screws to a torque of 9 in-lb (10 cm-kg).
Brocade G610 Hardware Installation Guide
53-1004408-08
Installing the 1U and 2U Non-Port Side Fixed-Mount Rack Kit (15"-20") for Four-Post Racks (XNA-000072 and XNA-100072)
3. Bracket, front right
55