Table of Contents
Advertisement
Standalone installation
CAUTION
Do not use the port cover tabs to lift the module. They are not designed to support the weight of the module, which can fall
and be damaged.
Standalone installation
Complete the following steps to install the device as a standalone unit on a table.
1.
Unpack the device and verify the items listed under the
2.
Place the device on a sturdy flat surface.
3.
Provide power to the device as described in
NOTE
Do not connect the device to the network until the IP address is set correctly. For instructions on how to set the IP
address, refer to
Installing the 1U, 1.5U, and 2U Mid-Mount Kit for
Two-Post Racks (XBR-000165, XBR-000175, and
XBR-R000292)
Use the following instructions to install a fixed-port device in a mid-mount configuration in a two-post rack using the 1U, 1.5U, and 2U
Mid-Mount Kit for Two-Post Racks (XBR-000165, XBR-000175, and XBR-R000292).
Observe the following when mounting this device:
•
Two people are required to install the device in a rack. One person holds the device, while the other secures the device to the
rack.
•
Hardware devices illustrated in these procedures are only for reference and may not depict the device you are installing into the
rack.
Time and items required
Allow 15 to 30 minutes to complete the installation procedure.
The following items are required to install a device using the 1U, 1.5U, or 2U Mid-Mount Kit for Two-Post Racks (XBR-000165,
XBR-000175, and XBR-R000292).
•
#2 Phillips torque screwdriver
•
1/4 inch slotted-blade torque screwdriver
NOTE
You may need two people to install the device, one to support the device, while the other secures it into the rack.
CAUTION
Use the screws specified in the procedure. Using longer screws can damage the device.
22
Providing power to the device
Configuring the IP address
Shipping carton contents
on page 59.
on page 60.
on page 20 are present and undamaged.
Brocade G610 Hardware Installation Guide
53-1004408-08
Hide quick links:
Advertisement
Table of Contents
