Attaching The Rear Brackets To The Front Brackets - Brocade Communications Systems G610 Hardware Installation Manual

Installing the 1U and 2U Fixed-Mount Rack Kit for Four-Post Racks (XBR-R000162)
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs (29 cm-kgs)
FIGURE 10 Positioning the device in the rack
1. Bracket, front left
2. Bracket, front right
NOTE
The figure above is shown with a recessed mounting configuration on the left and a flush mounting configuration on
the right. You can select either mounting option.
NOTE
Install the device with the airflow aligned with any other devices in the rack. Some devices have airflow running from
port side to fan side and others have the opposite arrangement. Make sure that the airflow for all devices moves in the
same direction to maximize cooling. Refer to the Hardware Installation Guide for your product for specific
requirements.

Attaching the rear brackets to the front brackets

Complete the following steps to attach the rear brackets to the front brackets.
1. Position the right rear bracket inside the right front bracket, as shown in the following figure.
2. Attach the brackets using four 6-32 x 1/4-in. screws.
32
3. Retainer nut, 10-32
4. Screw, 10-32 x 5/8-in., panhead Phillips
Brocade G610 Hardware Installation Guide
53-1004408-08