License options
•
One 1000/100/10 Mbps RJ45 connector Ethernet port for management. In conjunction with EZSwitchSetup, this port
supports switch IP address discovery and configuration, eliminating the need to attach a serial cable to configure the switch IP
address.
•
A RS-232 3-wire (Tx, Rx, and Gnd) universal asynchronous receiver/transmitter (UART) serial port to BMC adapter with a
RJ-45 connector for debugging initial switch setup (if not using EZSwitchSetup) and factory default restoration is included with
the switch. Although there are LEDs in the adapter, they are not used.
•
An internal e-USB module with 2 GB of persistent storage. This provides increased serviceability, and error logging functionality
by facilitating easier firmware upgrades and downloads of the system log files.
•
One external USB connector.
•
24 hot-pluggable SFP+ optical transceiver slots.
•
24 bicolor (green/amber) LEDs to indicate the status for each port.
•
One green LED to indicate valid system power.
•
One bicolor (green/amber) LED to indicate the system status.
•
Two Ethernet LEDs: one bicolor (green/amber) LED to indicate link speed (1000/100/10 Mbps) and one green LED to
indicate traffic activity.
•
A Serial EEPROM for switch identification.
•
Real-time fan monitoring.
•
Real-time digital thermometers for temperature monitoring.
•
Real-time clock (RTC) with battery.
License options
The Brocade G610 uses a capacity-based Dynamic Ports on Demand (POD) license method and can be purchased with 8, 16, or 24
licensed ports. The first eight ports (0-7) are enabled by default. To enable the remaining sixteen ports, you need to purchase and install
two 8-port POD license keys. Refer to the Brocade Fabric OS Software Licensing Guide for more details.
Port-side view
The following illustration shows the port-side view of the Brocade G610 Fibre Channel switch.
12
Brocade G610 Hardware Installation Guide
53-1004408-08