Brocade Communications Systems G610 Hardware Installation Manual page 39

5. Repeat these steps for the inner slide rail on the other side of the device.
FIGURE 18 Installing the inner rail to allow a device to slide out of the port side
1. Phillips screw, 8-32 x 3/16 in., zinc
NOTE
Two people are required to install the device in a rack. One person can hold the device while the other attaches it to the
rack.
Attaching the rack mount brackets
Perform the following steps to attach the rack mount brackets.
1. Position the right rack mount bracket next to the right side of the device, as shown in the following figure.
2. Attach the right rack mount bracket to the device using two slotted-head 8-32 x 3/8 in. screws. You can use either the regular
rack mount bracket or the alternate rack mount bracket. Be sure to be consistent on both sides of the device.
For recessed mounting, you can use the back rack mount brackets on the front instead of the left and right rack mount brackets.
3. Tighten the screws to a torque of 15 in-lbs (17 cm-kgs).
Brocade G610 Hardware Installation Guide
53-1004408-08
Slide Rack Mount Kit (XBR-R000070)
39