Brocade Communications Systems G610 Hardware Installation Manual page 47

2. Insert the power cords into the power cord clips, with the power cord prongs pointing toward the power source, as shown in the
following figure.
NOTE
Allow a minimum service loop of six inches at the device to ensure freedom to plug and unplug the power cords.
Ensure that the power cords route completely outside of the slide rails.
NOTE
Ensure that the power cords align in the clips and do not fall inside the slide rails. To prevent the cords from being
pulled out of the clips, unplug the cords from the device before moving the device on the slide rails.
FIGURE 25 Inserting the power cords in clips
1. Power cord
3. Position the device next to the rack; align and insert the inner rails inside the outer rails, as shown in the following figure.
Brocade G610 Hardware Installation Guide
53-1004408-08
Slide Rack Mount Kit (XBR-R000070)
2. Slide assembly
47