Brocade Communications Systems G610 Hardware Installation Manual page 70

Installing an SFP+ transceiver
NOTE
The 16- and 32-Gbps SFP+ transceivers do not have bails. Always use the pull tab to insert or remove the transceivers, as the
SFP might be hot.
1. Use the pull tab on the 16- and 32-Gbps SFP+ transceivers to help push the transceiver into the port. Transceivers are keyed
so that they can only be inserted with the correct orientation. If a transceiver does not slide in easily, ensure that it is correctly
oriented. Push the correctly oriented transceiver into the port until it is firmly seated and the latching mechanism clicks.
NOTE
Each SFP+ transceiver has a 10-pad gold-plated PCB-edge connector on the bottom. The correct position to insert
an SFP+ transceiver into the upper row of ports is with the gold edge down. The correct position to insert an SFP+
transceiver into the lower row of ports is with the gold edge up.
FIGURE 37 Installing a 32-Gbps SFP+ transceiver into an upper port
1. Pull tab
70
2. Transceiver
Brocade G610 Hardware Installation Guide
53-1004408-08