Checklist C Procedures - Rev A; Perform Engine Maintenance - Deutz Models; Grease The Platform Overload Mechanism (If Equipped) - Genie Z-60/34 Service Manual

Section 3 • Scheduled Maintenance Procedures
Checklist C Procedures
C-1
Perform Engine Maintenance -
Deutz Models
Deutz engine specifications require
that this procedure be performed
every 500 hours.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Required maintenance procedures and additional
engine information are available in the
Deutz FL 1011F Operation Manual
(Deutz part number 0297 9683).
Deutz FL 1011F Operation Manual
Genie part number
To access the engine:
1 Remove the two engine pivot plate retaining
bolts. Swing the engine pivot plate out away
from the machine and secure it from moving.
Crushing hazard. Failure to secure
the engine pivot plate from moving
could result in death or serious
injury.
3 - 36
C-2
Grease the Platform Overload
Mechanism (if equipped)
Application of lubrication to the platform overload
mechanism is essential to safe machine operation.
Continued use of an improperly greased platform
overload mechanism could result in the system not
sensing an overloaded platform condition and will
result in component damage.
1 Locate the grease fittings on each pivot pin of
the platform overload assembly.
52883
2 Thoroughly pump grease into each grease fitting
using a multi-purpose grease.
Genie Z-60/34
November 2003
Genie specifications require
that this procedure be performed
every 500 hours or 6 months,
whichever comes first. Perform
this procedure more often if dusty
conditions exist.
If your machine is not equipped
with grease fittings on the pivot
pins, remove the pivot pins and
grease them.
Part No. 75861
REV A