Displaying The Software Version Of The Hand-Held Transmitter, Parameter Code 002; Displaying The Hardware Version Of The Hand-Held Transmitter, Parameter Code 003; Parameter Code 004 - DEMAG DRC-10 Operating Instructions Manual

1.4 Displaying the soft-
ware version of the
hand-held transmitter,
Parameter code 002
1.5 Displaying the hard-
ware version of the
hand-held transmitter,
Parameter code 003
1.6 Display and entry of a
fixed frequency chan-
nel, Parameter code
004
1.6.1 Display mode
1.6.2 Entry and selection mode
The software version number of the hand-held transmitter is displayed with
parameter 002. It is only provided for information and cannot be changed. To
navigate, use the following keys:
Key Function
Right Change to display of parameter 003
Left Change to display of parameter 001
Lift Exit menu
The hardware version number of the hand-held transmitter is displayed with
parameter 003. It is only provided for information and cannot be changed. To
navigate, use the following keys:
Key Function
Right Change to display of parameter 004
Left Change to display of parameter 002
Lift Exit menu
This parameter makes it possible to determine the channel used by the radio
control system and, therefore, the frequencies used. If a channel is selected, the
radio control system uses it instead of searching for a free channel to establish a
connection.
The default setting set in the factory is 00, i.e. the radio control system is not
locked to a channel. For transmitters with the radio transmission method of
frequency hopping, utilization is only with setting 00.
The current channel selection is shown in the display. To navigate, use the
following keys:
Key Function
Right Change to display of parameter 005
Left Change to display of parameter 003
Lift Exit parameter programming menu
F1 Change to entry and selection mode
After changing to entry and selection mode, the channel can be selected from
possibilities 00 to 11:
Selection Meaning
00 no lock, search for a free channel to establish a connection
01 Locked to channel 1 (433.300 MHz and 434.300 MHz)
02 Locked to channel 2 (433.325 MHz und 434.325 MHz)
03 Locked to channel 3 (433.350 MHz und 434.350 MHz)
04 Locked to channel 4 (433.375 MHz und 434.375 MHz)
05 Locked to channel 5 (433.400 MHz und 434.400 MHz)
06 Locked to channel 6 (433.425 MHz und 434.425 MHz)
07 Locked to channel 7 (433.450 MHz und 434.450 MHz)
08 Locked to channel 8 (433.475 MHz und 434.475 MHz)
09 Locked to channel 9 (433.500 MHz und 434.500 MHz)
10 Locked to channel 10 (433.525 MHz und 434.525 MHz)
11 Locked to channel 11 (433.550 MHz und 434.550 MHz)
To select and to navigate, use the following keys:
Key Function
Right Display the next possible value
Left Display the previous possible value
Lift Exit parameter programming menu
F2 Accept the displayed setting
43